Dragino LPS8N
No image yet: needs device support
Dragino LPS8N indoor gateway, 8-channel.
| Board ID | dragino-lps8n |
|---|---|
| Image | No image yet: needs device support |
| Install | From the running system or the bootloader |
| OpenWrt | 25.12.6, ath79/generic, mips_24kc |
| Features | LoRaWAN, WiFi |
| LoRa radio | 8 channels, one concentrator on SPI |
| Concentrator part | sx1302_spi, dragino_pg1302 |
| Slot 0 | SPI /dev/spidev1.0, reset GPIO 23 |
| GNSS | Probed |
| Bluetooth | None |
| Local screen | None |
| USB device port | None |
| LAN ports | None |
| Built-in add-ons | None |
Panel lights
| Label | Colour | Role | sysfs |
|---|---|---|---|
| SYS | red | status | dragino2:red:system |
| WAN | red | ethernet | dragino2:red:wan |
| LAN | red | ethernet | dragino2:red:lan |
| WLAN | red | wifi | red:wlan |
Install
No image is built for this board yet. Its OpenWrt device support is in the repository and has to build and boot on a unit first.
The first install, recovery and the hardware record:boards/dragino-lps8n/openwrt/README.md.
Notes from board.conf
Atheros AR9331 (ath79/generic), 16MB flash, one Dragino PG1302 (SX1302) on bit-banged SPI, /dev/spidev1.0. Upstream OpenWrt has the older LPS8, not this one, so the device support is openwrt/ beside this file: ChirpStack Gateway OS's device tree (GPL-2.0-or-later OR MIT) ported to 25.12, built into an ImageBuilder by scripts/device-imagebuilder.sh. The concentrator's reset is GPIO 23, concentratord's default for a PG1302, which ChirpStack's own LPS8N configuration relies on (its OpenWrt feed, MIT). Its ChirpStack binaries are the ones in ChirpStack Gateway OS for this board (feed/chirpstack-gateway).
Needs device support until that repo's first release is out; then BOARD_STATUS goes to supported. Not yet run on a unit.
Source: boards/dragino-lps8n/board.conf