Skip to content

GL.iNet GL-SFT1200 Opal

Image built by CI

GL.iNet GL-SFT1200 (Opal): a router, not a LoRa gateway.

Board IDgl-sft1200
ImageImage built by CI
InstallFrom the running system or the bootloader
OpenWrt25.12.6, siflower/sf19a2890, mipsel_24kc_24kf
FeaturesCellular, WiFi, LAN ports, DNS, Uplink failover, Speed test
LoRa radioNone
GNSSNone
BluetoothNone
Local screenNone
USB device portNone
LAN portslan1, lan2
Built-in add-onsNone

Install

This board boots from soldered flash. A unit already running PulzrOS upgrades from its console or withsysupgrade (Firmware updates).

The first install, recovery and the hardware record:boards/gl-sft1200/openwrt/README.md.

Notes from board.conf

The board a site's IP devices sit behind, on its two LAN ports; the first is an Arduino Opta PLC. One WAN port, a MaxLinear GSW150 switch, 128MB of SPI NAND, USB 2.0, 5V over USB-C. No LoRa radio, no GNSS, no Bluetooth.

OpenWrt has no device for it, and its siflower/sf19a2890 target is source-only with a 6.12 kernel that has no GSW150 driver. The device support lives in openwrt/ beside this file: 25.12.6 userland, so this board runs the same feed as every other, on siflower's 6.18 kernel with the switch. Its README is the hardware record and the harvest and recovery procedure. The harvested unit runs PulzarOS 0.3.5 on 25.12.6-2: the switch, devlan, the WAN console and the TUI work; adoption, cellular and failover are not yet seen.

Source: boards/gl-sft1200/board.conf