Skip to content

Raspberry Pi 5

Image built by CI

Raspberry Pi 5.

Board IDrpi5
ImageImage built by CI
InstallSD card
OpenWrt25.12.6, bcm27xx/bcm2712, aarch64_cortex-a76
FeaturesLoRaWAN, Cellular, WiFi, GNSS, Speed test
LoRa radioProbed: SPI, USB or UART
Slot 0probed on every bus, editable in the console
GNSSProbed
BluetoothNone
Local screenHDMI
USB device portdwc2 (console over USB)
LAN portsNone
Built-in add-onsNone

Install

Write the image to an SD card with any writer, or:

Terminal window
./flash.sh --download rpi5

See Flashing.

Notes from board.conf

Two caveats worth knowing before you build one, neither of which changes the configuration here:

* OpenWrt's bcm2712 support is newer than the other two. Confirm the
profile name against the release you are pinned to before trusting a
build — `make info` in the ImageBuilder lists them.
* The Pi 5 moved GPIO behind the RP1 southbridge. The pin *numbers* are
unchanged, so the reset line is still 17 on a standard HAT, but the
gpiochip is not necessarily gpiochip0 any more. That is why
PULZR_GPIOCHIP exists and is set here — pulzr-sx130x-reset reads it,
and a wrong value looks exactly like a concentrator that is not plugged
in.

Source: boards/rpi5/board.conf