RAK7268CV2 WisGate Edge Lite 2
Image built by CI
RAK7268CV2 — WisGate Edge Lite 2 V2, 8-channel, with LTE.
| Board ID | rak7268cv2 |
|---|---|
| Image | Image built by CI |
| Install | From the running system or the bootloader |
| OpenWrt | 25.12.6, ramips/mt76x8, mipsel_24kc |
| Features | LoRaWAN, Cellular, WiFi |
| LoRa radio | 8 channels, one concentrator on SPI |
| Concentrator part | sx1302_spi, rak_2287 |
| Slot 0 | SPI /dev/spidev0.1, reset GPIO 11 |
| GNSS | None |
| Bluetooth | None |
| Local screen | None |
| USB device port | None |
| LAN ports | None |
| Built-in add-ons | None |
Panel lights
| Label | Colour | Role | sysfs |
|---|---|---|---|
| Status | rgb | cloud | rgb:status |
| LoRa 1 | green | lora | green:lora-1 |
| LoRa 2 | green | lora | green:lora-2 |
| ETH | green | ethernet | green:lan |
| WLAN | orange | wifi | orange:wlan |
Install
This board boots from soldered flash. A unit already running PulzrOS upgrades from its console or withsysupgrade (Firmware updates).
The first install, recovery and the hardware record:boards/rak7268cv2/openwrt/README.md.
Notes from board.conf
Verified against a stock unit (WisGateOS 2.2.16) on 2026-09-16 — the raw facts are in openwrt/README.md. Internally it is a RAK636 module: MT7628AN, 32MB SPI NOR, one SX1302 + two SX1250s, Quectel EG95 on USB, and an SD card on the pins the other four ethernet ports would have used.
OpenWrt has no device for it, so the device support lives in openwrt/ beside this file, built into an ImageBuilder by scripts/device-imagebuilder.sh. Installed from U-Boot over TFTP; see openwrt/README.md.
Source: boards/rak7268cv2/board.conf