Skip to content

RAK7289V2 WisGate Edge Pro

Image built by CI

RAK7289V2 — WisGate Edge Pro V2, 16-channel, no LTE.

Board IDrak7289v2
ImageImage built by CI
InstallFrom the running system or the bootloader
OpenWrt25.12.6, ramips/mt76x8, mipsel_24kc
FeaturesLoRaWAN, WiFi, GNSS
LoRa radio16 channels, 2 concentrators on USB
Concentrator partsx1302_usb, rak_5146
Slot 0USB /dev/lora0, reset lora-reset
Slot 1USB /dev/lora1
GNSSBuilt in
BluetoothNone
Local screenNone
USB device portNone
LAN portsNone
Built-in add-onsNone

Panel lights

LabelColourRolesysfs
LoRa 1greenloragreen:lora-1
LoRa 2greenloragreen:lora-2
ETHgreenethernetgreen:lan
WLANorangewifiorange:wlan

Install

This board boots from soldered flash. A unit already running PulzrOS upgrades from its console or withsysupgrade (Firmware updates).

Notes from board.conf

The RAK7289CV2 without its modem: the same RAK636 module, the same two RAK5146 mPCIe cards on USB. ChirpStack's OpenWrt feed (MIT, chirpstack-concentratord-target-rak7289v2) configures its two slots as this repo does the CV2's -- rak_5146 on the first and second CDC-ACM ports, GNSS on the first card, reset on GPIO 11 for the first -- and ChirpStack Gateway OS builds every RAK636 board from one device profile. So this is the CV2's device support and image with the cellular side left out.

Not yet run on a V2 unit. The hub-port mapping (PULZR_LORA_USB_PORTS) and the power board are the CV2's and are the things to confirm first.

Source: boards/rak7289v2/board.conf