GL.iNet GL-SFT1200 Opal
Image built by CI
GL.iNet GL-SFT1200 (Opal): a router, not a LoRa gateway.
| Board ID | gl-sft1200 |
|---|---|
| Image | Image built by CI |
| Install | From the running system or the bootloader |
| OpenWrt | 25.12.6, siflower/sf19a2890, mipsel_24kc_24kf |
| Features | Cellular, WiFi, LAN ports, DNS, Uplink failover, Speed test |
| LoRa radio | None |
| GNSS | None |
| Bluetooth | None |
| Local screen | None |
| USB device port | None |
| LAN ports | lan1, lan2 |
| Built-in add-ons | None |
Install
This board boots from soldered flash. A unit already running PulzrOS upgrades from its console or withsysupgrade (Firmware updates).
The first install, recovery and the hardware record:boards/gl-sft1200/openwrt/README.md.
Notes from board.conf
The board a site's IP devices sit behind, on its two LAN ports; the first is an Arduino Opta PLC. One WAN port, a MaxLinear GSW150 switch, 128MB of SPI NAND, USB 2.0, 5V over USB-C. No LoRa radio, no GNSS, no Bluetooth.
OpenWrt has no device for it, and its siflower/sf19a2890 target is source-only with a 6.12 kernel that has no GSW150 driver. The device support lives in openwrt/ beside this file: 25.12.6 userland, so this board runs the same feed as every other, on siflower's 6.18 kernel with the switch. Its README is the hardware record and the harvest and recovery procedure. The harvested unit runs PulzarOS 0.3.5 on 25.12.6-2: the switch, devlan, the WAN console and the TUI work; adoption, cellular and failover are not yet seen.
Source: boards/gl-sft1200/board.conf