RAK7289CV2 WisGate Edge Pro
Image built by CI
RAK7289CV2 — WisGate Edge Pro V2, 16-channel, with LTE.
| Board ID | rak7289cv2 |
|---|---|
| Image | Image built by CI |
| Install | From the running system or the bootloader |
| OpenWrt | 25.12.6, ramips/mt76x8, mipsel_24kc |
| Features | LoRaWAN, Cellular, WiFi, GNSS |
| LoRa radio | 16 channels, 2 concentrators on USB |
| Concentrator part | sx1302_usb, rak_5146 |
| Slot 0 | USB /dev/lora0, reset lora-reset |
| Slot 1 | USB /dev/lora1 |
| GNSS | Built in |
| Bluetooth | None |
| Local screen | None |
| USB device port | None |
| LAN ports | None |
| Built-in add-ons | pulzr-modbus |
Panel lights
| Label | Colour | Role | sysfs |
|---|---|---|---|
| LoRa 1 | green | lora | green:lora-1 |
| LoRa 2 | green | lora | green:lora-2 |
| ETH | green | ethernet | green:lan |
| WLAN | orange | wifi | orange:wlan |
Install
This board boots from soldered flash. A unit already running PulzrOS upgrades from its console or withsysupgrade (Firmware updates).
The first install, recovery and the hardware record:boards/rak7289cv2/openwrt/README.md.
Notes from board.conf
TWO concentrators, and that is the interesting thing about this board.
Sixteen channels is not one concentrator with twice the channels; it is two eight-channel parts, each its own process. Concentratord drives one part per process, so this board runs two packet forwarders — see feed/pulzr-concentrator/files/etc/init.d/pulzr-packet-forwarder, which spawns one instance per slot, and docs/src/content/docs/concentrators.md for how the two are presented upstream as a single gateway.
This board is the reason the slot model exists. Everything else in the fleet happens to have one slot; treating that as the general case would have made this board a fork.
The parts are on USB, not SPI
Read from RAK's shipping firmware, which is authoritative for its own hardware (the ChirpStack Gateway OS RAK image and RAK's WisGateOS both drive this board): the Pro's two radios are RAK5146 (SX1303) mPCIe cards, and each presents to Linux as a USB CDC-ACM device — /dev/ttyACM0 and /dev/ttyACM1 — not as an SX130x on a SPI bus, where the RAK7268CV2 Lite has a single SX1302 soldered to SPI CS1. So there is no SPI concentrator, and nothing for concentratord to reset (the RAK5146's own STM32 owns the SX1303's reset — see the note in pulzr-lora-config); the image carries kmod-usb-acm.
The device support (a DTS and an OpenWrt patch) lives in openwrt/ beside this file, built into an ImageBuilder by scripts/device-imagebuilder.sh. It shares the RAK636 module, and its flash map, with the Lite, but not its control lines: RAK writes each unit's in a hardware descriptor in the factory partition (pulzr-hwdesc), and on this board the device tree exports them by name — modem-reset on GPIO 2 (the Lite's is 42), lora-reset (the first slot's card, GPIO 17) and gnss-reset (GPIO 16). See pulzr-hwline.
Source: boards/rak7289cv2/board.conf