RAK7289V2 WisGate Edge Pro
Image built by CI
RAK7289V2 — WisGate Edge Pro V2, 16-channel, no LTE.
| Board ID | rak7289v2 |
|---|---|
| Image | Image built by CI |
| Install | From the running system or the bootloader |
| OpenWrt | 25.12.6, ramips/mt76x8, mipsel_24kc |
| Features | LoRaWAN, WiFi, GNSS |
| LoRa radio | 16 channels, 2 concentrators on USB |
| Concentrator part | sx1302_usb, rak_5146 |
| Slot 0 | USB /dev/lora0, reset lora-reset |
| Slot 1 | USB /dev/lora1 |
| GNSS | Built in |
| Bluetooth | None |
| Local screen | None |
| USB device port | None |
| LAN ports | None |
| Built-in add-ons | None |
Panel lights
| Label | Colour | Role | sysfs |
|---|---|---|---|
| LoRa 1 | green | lora | green:lora-1 |
| LoRa 2 | green | lora | green:lora-2 |
| ETH | green | ethernet | green:lan |
| WLAN | orange | wifi | orange:wlan |
Install
This board boots from soldered flash. A unit already running PulzrOS upgrades from its console or withsysupgrade (Firmware updates).
Notes from board.conf
The RAK7289CV2 without its modem: the same RAK636 module, the same two RAK5146 mPCIe cards on USB. ChirpStack's OpenWrt feed (MIT, chirpstack-concentratord-target-rak7289v2) configures its two slots as this repo does the CV2's -- rak_5146 on the first and second CDC-ACM ports, GNSS on the first card, reset on GPIO 11 for the first -- and ChirpStack Gateway OS builds every RAK636 board from one device profile. So this is the CV2's device support and image with the cellular side left out.
Not yet run on a V2 unit. The hub-port mapping (PULZR_LORA_USB_PORTS) and the power board are the CV2's and are the things to confirm first.
Source: boards/rak7289v2/board.conf