RAK7391 WisGate Connect
Image built by CI
RAK7391 — WisGate Connect, a Raspberry Pi CM4 carrier.
| Board ID | rak7391 |
|---|---|
| Image | Image built by CI |
| Install | SD card |
| OpenWrt | 25.12.6, bcm27xx/bcm2711, aarch64_cortex-a72 |
| Features | LoRaWAN, Cellular, WiFi, GNSS, Speed test |
| LoRa radio | Probed: SPI, USB or UART |
| Slot 0 | probed on every bus, editable in the console |
| GNSS | Probed |
| Bluetooth | On the UART |
| Local screen | HDMI |
| USB device port | dwc2 (console over USB) |
| LAN ports | None |
| Built-in add-ons | None |
Install
Write the image to an SD card with any writer, or:
./flash.sh --download rak7391See Flashing.
Notes from board.conf
Two mPCIe slots that take whichever LoRa card was ordered: a RAK5146 on USB (the usual one), a RAK5146 or RAK2287 on SPI, or a RAK5148 2.4 GHz card. So unlike the WisGate Edge units the radio is not soldered down, and the slots are probed and operator-editable as on a kit. ChirpStack's OpenWrt feed (MIT, chirpstack-concentratord-target-rak7391) gives the card resets: GPIO 17 for the first slot and GPIO 6 for the second -- the values to put in the console for an SPI card.
The CM4 is a BCM2711, so this is the Pi 4 image and OpenWrt's own rpi-4 profile (Gateway OS builds the carrier 32-bit, as rpi-2; nothing here needs that). Not yet run on a unit: the carrier's fan controller, RTC and PoE board are not driven.
Source: boards/rak7391/board.conf