Raspberry Pi 5
Image built by CI
Raspberry Pi 5.
| Board ID | rpi5 |
|---|---|
| Image | Image built by CI |
| Install | SD card |
| OpenWrt | 25.12.6, bcm27xx/bcm2712, aarch64_cortex-a76 |
| Features | LoRaWAN, Cellular, WiFi, GNSS, Speed test |
| LoRa radio | Probed: SPI, USB or UART |
| Slot 0 | probed on every bus, editable in the console |
| GNSS | Probed |
| Bluetooth | None |
| Local screen | HDMI |
| USB device port | dwc2 (console over USB) |
| LAN ports | None |
| Built-in add-ons | None |
Install
Write the image to an SD card with any writer, or:
./flash.sh --download rpi5See Flashing.
Notes from board.conf
Two caveats worth knowing before you build one, neither of which changes the configuration here:
* OpenWrt's bcm2712 support is newer than the other two. Confirm the profile name against the release you are pinned to before trusting a build — `make info` in the ImageBuilder lists them.* The Pi 5 moved GPIO behind the RP1 southbridge. The pin *numbers* are unchanged, so the reset line is still 17 on a standard HAT, but the gpiochip is not necessarily gpiochip0 any more. That is why PULZR_GPIOCHIP exists and is set here — pulzr-sx130x-reset reads it, and a wrong value looks exactly like a concentrator that is not plugged in.Source: boards/rpi5/board.conf