SenseCAP M2
No image yet: needs device support
Seeed SenseCAP M2 Multi-Platform gateway, 8-channel.
| Board ID | sensecap-m2 |
|---|---|
| Image | No image yet: needs device support |
| Install | From the running system or the bootloader |
| OpenWrt | 25.12.6, ramips/mt76x8, mipsel_24kc |
| Features | LoRaWAN, WiFi |
| LoRa radio | 8 channels, one concentrator on SPI |
| Concentrator part | sx1302_spi, seeed_wm1302 |
| Slot 0 | SPI /dev/spidev0.1, reset GPIO 14, power GPIO 3 |
| GNSS | Probed |
| Bluetooth | None |
| Local screen | None |
| USB device port | None |
| LAN ports | None |
| Built-in add-ons | None |
Panel lights
| Label | Colour | Role | sysfs |
|---|---|---|---|
| LoRa | green | lora | green:lora |
| WAN | green | ethernet | green:wan |
| WLAN | green | wifi | green:wlan |
Install
No image is built for this board yet. Its OpenWrt device support is in the repository and has to build and boot on a unit first.
The first install, recovery and the hardware record:boards/sensecap-m2/openwrt/README.md.
Notes from board.conf
Its SenseCAP WM7628N module: MT7628 (ramips/mt76x8), 32MB flash, an SD card, and a Seeed WM1302 (SX1302) on /dev/spidev0.1 -- reset GPIO 14, power-enable GPIO 3, the SX1261's reset GPIO 15 (ChirpStack's OpenWrt feed, MIT; PulzarOS does not do listen-before-talk, so the SX1261 is left alone). Upstream OpenWrt has no device for it, so the device support is openwrt/ beside this file: ChirpStack Gateway OS's device tree (GPL-2.0-or-later OR MIT) ported to 25.12, keeping the stock board name so the image is accepted from Seeed's firmware.
Needs device support until that repo's first release is out; then BOARD_STATUS goes to supported. Not yet run on a unit.
Source: boards/sensecap-m2/board.conf